• FMT-400-Ethernet Module

- Provides the FMT-400 with an Ethernet Fieldbus connection -

Introduction

The 400-ETHERNET module provides the FMT-400 system with means to communicate with remote equipment over a Ethernet network. For instance the FMT-400 could be a remote node in a SCADA network communicating over a Ethernet network. A maximum of one 400-ETHERNET module is supported by the 400-CPU-B, and a maximum of four 400-ETHERNET modules are supported by the 400-CPU-C. The 400-ETHERNET module must be used in the main rack of the FMT-400 system.

Programming and setup is done in FLEX; the 400-ETHERNET modules are assigned to the required rack in the PROJECT CONFIGURATION menu box when all the modules within each rack can be assigned. A RJ45 connector is used on the 400-ETHERNET modules for connection to remote systems. The IP address is set on the front of the modules via DIP switched; this allows the user to assign a unique IP address to each modules to allow direct communicatons between systems.

Features

  • Provides the FMT-400 with an Ethernet Fieldbus connection
  • Allows FMT-400 to act as a remote node in a SCADA system over a Ethernet network via a RJ45 connector

See Datasheet [78KB]

Write a review

Note: HTML is not translated!
    Bad           Good

FMT-400-Ethernet Module

  • Brand: Colter Products
  • Product Code: FMT-400-Ethernet Module
  • Availability: In Stock
  • £536.56


  • 5 or more £482.91
  • 16 or more £456.08
  • 50 or more £429.25

Tags: FMT-400-CPU-CFMT-400-CPU-C, Programmable Controller, PLC, Processor, CPU, CPUC, CPU-C, FMT, FMT400, 400